We are devoted to research and development, production, and sales of road, bridge, mining, tunnel construction equipment, and some other machinery. Henan YG Machinery is a top and professional manufacturer of various drilling machines, such as small water well drilling machines, rock drill machines, core drilling machines, DTH drilling machines, horizontal direction drilling machines, rotary drilling rigs, hydraulic pile drivers, anchor drilling rigs, etc… We have specialized in the production of machinery for more than twenty years. Mud Pump for Sale in YG Machinery Manufacturer When shifting is required, the pump should be stopped. It is strictly forbidden to shift gears during operation.There are several speed mud pumps to make the splash lubrication reliable and should run at several speeds in each shift, the time is not less than 30 seconds.The mud content of the mud should not be tested to more than 10% during operation.Pull rods and auxiliary rods should always be lubricated with oil. Pay attention to the sealing of each sealing device during operation and adjust if necessary.After starting, the load will be gradually increased after the operation is normal. If there is no obstruction and the line insulation is good, it can be started without load. Rotate by hand to make the piston reciprocate twice.Before the submerged mud pump is started, the suction pipe, the bottom valve, and the pump body must be filled with water, and the upper end of the pressure gauge buffer is filled with oil.Check before starting: The connection parts should be tightened the direction of the electric rotation should be correct the clutch is flexible and reliable the pipeline connection is firm, the seal is reliable, and the bottom valve is flexible and effective.YG250 Mud Pump for Mine Operating Procedures: The effect of the mud on the suction capacity should be considered when pumping the mud. The allowable suction stroke of the mud pump is measured when the clean water is delivered. The clearance adjustment can be performed by adjusting the screws on the rear bearing body. Therefore, when replacing the impeller, care should be taken to ensure that the clearance meets the requirements of the drawing. If the gap is unreasonable, vibration and noise will occur when the pump is running, and the overcurrent components will be damaged quickly. Whether the gap between the impeller and the guard plate is reasonable has a great influence on the life of the mud pump. Otherwise, the sealing part will wear quickly. The mud pump should not be closed when the mud pump is working. The mud pump should be equipped with a high-pressure clean water pump to transport the clean water then the mud pump pressure to the leak-proof packing to protect the packing. If the bearing is filled with butter before and after, check if the packing is full. Uniform flow, low-pressure fluctuations.īefore starting the mud pump, please check if the inlet pipe and outlet pipe are blocked.Detachable, easy to repair, and relocate.The pump has the characteristics of stable operation, wide flow variation range, high output pressure, and stable performance.The pump is a horizontal three-cylinder reciprocating single-acting piston pump.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |